AQUAJET/AQUAJET JR. PARTS

Pick any two Filter Bags with Free Shipping (one of each or two of the same). Choose between the standard 2 micron filter bag. Or the leaf filter bag (picks up larger debris without restricting the water flow.) Fits all residential Aquabot and Watertech units . . .asd

List which two bag you would like in the CUSTOMER NOTES section during checkout. 

• Standard 2 Micron (8111)
•  Leaf & Large Debris Bag (8112)

This is the standard 2 micron filter bag. Fits all residential Aquabot and Watertech units

Used to seal 2-wire connections

Aquabot Parst Kit - Drive Belt & Bushings

All Units.

For fastening the foam-insulated part of a 2-wire cable to the Body Assembly.

For end of Cable Assembly. Always Disconnect power before working on the electrical system!

Helps to take the curls out of the power cord.

Outer housing  for all Jet and Rover Units and Screen

For Center Wheel on Jet and Rover Units. - Free Moving bracket for small black wheel.

Used to fasten the Lock-Tabs to the Body Assembly.

Used to fasten the Screws of the Lock-Tabs to the Body Assembly.

Used around the Cable Assembly on the Body Assembly. For AquaJet, JetMax and Pool Rover Units.

Black, For under sideplate. For use with Pool Rover Plus, ThunderJet IG, AquaJet, JetMax

Pump-Motor-A6005-03, S1A6014 

Used on all units within wheel or wheel tube.

Clevis Pin (Stainless Steel) 1/4"x2.232"

Foam, Plastic and screws. This float gets fastened to bottom lid if cleaner is not climbing the wall high enough.

White Foam Blocks. These are inserted into the bottom lid if the unit is not climbing high enough. (The H-Float must be installed in order to install the Side Pocket Floats)

(3-pin, male, 2-wire) Aquabot, Turbo, Storm, Tempo, Turbo T, T2 Always unplug unit before working on electrical system!

Thin Red, 3-wire. Always unplug unit before working on electrical system.

Black plastic, with screws, nuts and star washers.

Snaps into place on main drain grate - keeps unit from getting stuck on main drain.