AQUABOT PLUS RC PARTS

Pick any two Filter Bags with Free Shipping (one of each or two of the same). Choose between the standard 2 micron filter bag. Or the leaf filter bag (picks up larger debris without restricting the water flow.) Fits all residential Aquabot and Watertech units . . .asd

List which two bag you would like in the CUSTOMER NOTES section during checkout. 

• Standard 2 Micron (8111)
•  Leaf & Large Debris Bag (8112)

Tan belts. If you are changes your drive belts, we also suggest replacing your #51-Bushings and inspect your #58-Drive Pulley for wear. Any wear in these items can cause slack in your drive belts and reduce their longevity. We also suggest installing a belt tensioner device to take up any slack in your belts.

Front Digital Display, 1-7 Hours Adjustable

Aquabot Parst Kit - Drive Belt & Bushings

This is the standard 2 micron filter bag. Fits all residential Aquabot and Watertech units

White Plastic, 1/2" Hole, 2 notches.

Bracket fo Handle (Blue)

Round Head, hole in end.

Beige Supports Drive Belts, installs on the upper Sideplate leg. In 2004, Aqua Products switched to the Beige Stepped Sleeve Roller, which is slightly thicker than the white ones. This change helps the belts stay tighter, which helps prevent abnormal wear. If you have an older unit we suggest upgrading to the beige rollers. Each unit has 2 #56. Stepped Sleeve Rollers.

Always unplug the unit before working on electrical system!

Use between Handle Bracket and Cotter Ring inside most Handle Assemblies 

Use to fasten Clevis Pin inside the Handle Bracket of most units.

Aluminum, 3/16"  

10-32, 7/8" Phil Pan Head

For fastening the non-foam-insulated part of a 4-wire cable to the Body Assembly.

Used to attach the side plate to the body assembly. On the T4, used to fasten the clamps around the DC pump to the Plate Block. On the T2, used to fasten drive motor to the body assembly.

Used on Aquabot Plus RC and Aquabot Ultra. Always unplug unit before working on electrical system.

Top and bottom, glue ring to Body Assembly with PVC Glue.

Plastic, White. Not required on most units. Set of 4.

Hex, Nylon Insert. For fastening the screws of the Anti-Roll Brackets. On the T4, used to attach screws of the Clamp and attach it to the Sideplate.

All Units.

Used to fasten Clamp and Piston on the Sideplate of a Model "G" unit.

3/4" long stainless steel. Used in the end of the Drive Motor shaft, use Lok-Tite when installing.

Used on all units within wheel or wheel tube.

Used to fasten the 5300/5301 Filter Screen to the Body Assembly.

Standard, push and turn style. Always unplug unit before working on electrical system!

Standard Red, 3-wire. Always unplug unit before working on electrical system.

Black plastic, with screws, nuts and star washers.

Snaps into place on main drain grate - keeps unit from getting stuck on main drain.