ULTRAMAX JUNIOR PARTS

:
from
to
Clear all
Products: 1–72 of 72
Show:100
Sort by:Recommended

  • 1. Handle Assembly

    Blue and white, bracket included. For Aquamax Bi-Turbo and Ultramax Jr.
    • $122.96

  • 2. Bracket for Handle (Blue)

    Bracket fo Handle (Blue)

    • $34.85

  • Aqua Products — 4. Clevis Pin

    Round Head, hole in end.

    • $3.86

  • Washer

    Use between Handle Bracket and Cotter Ring inside most Handle Assemblies 

    • $0.83

  • Cotter Ring

    Use to fasten Clevis Pin inside the Handle Bracket of most units.

    Aluminum, 3/16"  

    • $0.83

  • 8. Screw

    10-32, 7/8" Phil Pan Head

    • $1.27

  • 9., 48. Screw (#8, 11/16", Phil Pan Head)

    Used for side plate on Older units.

    • $1.27

  • 11. Hook

    Stainless Steel Snap Hook with eyelet for pin. Used to hold rope to Ultramax.
    • $2.86

  • 12. P-Clip (5/8", Coated Steel)

    Used to fasten the insulated part of a 4, 7 or 9-wire cable to the Handle Assembly.
    • $2.44

  • 12. P-Clip (11/16", Stainless Steel)

    Used to fasten the foam-insulated part of a 9-wire cable to the Handle Assembly.
    • $2.30

  • 12. P-Clip (11/16", Plastic)

    Used to fasten the foam-insulated part of a 9-wire cable to the Handle Assembly. (We suggest the stainless steel P-Clip)
    • $1.20

  • 13., 74. or 81. Screw (#8, 11/16", Phil Pan-Flat Head.

    Used to attach the side plate to the body assembly. On the T4, used to fasten the clamps around the DC pump to the Plate Block. On the T2, used to fasten drive motor to the body assembly.

    • $1.27

  • 15. Plug (9-pin, Female, 9-wire)

    Used on Ultramax Jr. and Ultramax.Always unplug unit before working on electrical system!
    • $45.79

  • 16. EZ-SWIVEL

    For 5 and 7 wire cables.
    • $46.62

  • 17. Cable Assembly (9-wire, 120 feet, Floating)

    For Ultramax and Ultramax Jr.
    • $737.13

  • 17. Cable Assembly (9-wire, 150 feet, Floating)

    For Ultramax and Ultramax Jr.
    • $912.18

  • 25. Outlet Top (Top, Bottom and Cap)

    For Ultramax and Ultramax Jr.
    • $30.32

  • 26. Body Assembly - Ultramax Jr.

    White with holes, lock tabs, outlet ring and inserts.
    • $215.60

  • 27., 62. Screw (8-18, 3/4", Phil No-Head

    Used to fasten the Pump Motor to the Outlet Bottom Ring on the Body Assembly.
    • $1.27

  • 28. Shell (Small, Beige)

    Used on Ultramax Jr.
    • $92.11

  • 30. or 74. Lock-Nuts Set of 8

    Hex, Nylon Insert. For fastening the screws of the Anti-Roll Brackets. On the T4, used to attach screws of the Clamp and attach it to the Sideplate.

    • $1.33

  • 38. Screws (18-8, 8/32"x1/2", Phil-Bev Head)

    Used to fasten the Lock-Tabs to the Body Assembly.

    • $1.27

  • 39. Lock-Nut (Nylon Insert, Hex)

    Used to fasten the Screws of the Lock-Tabs to the Body Assembly.

    • $0.83

  • 45. Sideplate

    Blue, 6 holes, 4 for bolts, 2 for motor access. For AB Plus RC, AB Ultra, AMAX, AMAX Biturbo, Ultramax JR, UMAX
    • $30.32

  • 49. Screw

    Bolts, Long, For Sideplate.
    • $1.19

  • 51. Bushing

    White Plastic, 1/2" Hole, 2 notches.

    • $4.95

  • 54. Small Roller

    White plastic. Supports the Drive Track, install on lower legs of the Sideplate.
    • $2.76

  • 56. Stepped Sleeve Roller

    Beige Supports Drive Belts, installs on the upper Sideplate leg. In 2004, Aqua Products switched to the Beige Stepped Sleeve Roller, which is slightly thicker than the white ones. This change helps the belts stay tighter, which helps prevent abnormal wear. If you have an older unit we suggest upgrading to the beige rollers. Each unit has 2 #56. Stepped Sleeve Rollers.

    • $2.90

  • 57. Drive Belts (per pair)

    Tan belts. If you are changes your drive belts, we also suggest replacing your #51-Bushings and inspect your #58-Drive Pulley for wear. Any wear in these items can cause slack in your drive belts and reduce their longevity. We also suggest installing a belt tensioner device to take up any slack in your belts.

    • $19.99

  • 58. Pulley Assembly (Medium)

    Used on all Black Drive Motors. Approximately 2.75-inches long.
    • $33.81

  • 58. Pulley Assembly (Long)

    Old Style. Used with Long-Legged Motor or used with Spacer Bracket.
    • $33.81

  • 60. Pump Motor

    For the Aquabot Plus RC, AB Ultra, Aquamax Jr. Plus, Aquamax, Aquamax B-Turbo, Ultramax Jr. and Ultramax.Pump motor comes with a 6 month factory warranty if it is installed by a factory authorized repair center. (Aqua Service Distributors is a factory authorized repair center.) If the motor is not installed by an authorized service center there is not warranty and the the motor cannot be returned. Always disconnect the power before working on the electrical system.
    • $282.74

  • 61. Propeller

    All Units.

    • $14.95

  • 79. JUNCTION BOX ASSEMBLY

    Connections: 9-pin, 2 pump motors, 2 drive motors
    • $209.88

  • 79. JUNCTION BOX ASSEMBLY

    Connections: 9-pin, 2 pump motors, 2 Infra-Red Sensors, 2 drive motors
    • $227.37

  • 80. Drive Motor (MASTER, black)

    For Ultramax and Ultramax Jr. Drive motor comes with a 6 month factory warranty if it is installed by a factory authorized repair center. (Aqua Service Distributors is a factory authorized repair center.) If the motor is not installed by an authorized service center there is not warranty and the the motor cannot be returned. Always disconnect the power before working on the electrical system.
    • $582.91

  • 80. Drive Motor (MASTER, Black, BB Air Sensor)

    For Ultramax and Ultramax Jr. Drive motor comes with a 6 month factory warranty if it is installed by a factory authorized repair center. (Aqua Service Distributors is a factory authorized repair center.) If the motor is not installed by an authorized service center there is not warranty and the the motor cannot be returned. Always disconnect the power before working on the electrical system.
    • $582.91

  • 80. Drive Motor (SLAVE, Green)

    For all units that require two motors.
    • $519.66

  • 83. Spiral Pin

    3/4" long stainless steel. Used in the end of the Drive Motor shaft, use Lok-Tite when installing.

    • $4.27

  • 86. Shrinkable Butt Connectors (pair)

    Light Blue, crimp closed and head shrink to seal.
    • $2.54

  • 87. SHRINK TUBE - 1/2" PER FOOT

    Used to seal 2-wire connections, use over heat shrink SP1617
    • $11.66

  • 88. SHRINK TUBE - 3/4" PER FOOT

    Used to seal all medium sized connections at Junction Box.
    • $11.66

  • 89. SHRINK TUBE (1-1/2", 2.5")

    Used for sealing large Cable connections.
    • $2.44

  • 90. Wheel Tube Assembly

    For Aquabot Ultra and Ultramax Jr.
    • $108.44

  • 90. Wheel Tube Assembly - Model "G"

    For Aquabot Ultra and Ultramax Junior.
    • $108.44

  • 91. Retaining Ring

    Stainless Steel "E" Clip
    • $4.99

  • 92. Washer (Nylon, Flat)

    Used on all units within wheel or wheel tube.

    • $1.39

  • 96. Screw (Small used to fasten wheeltube brace to body)

    For Aquabot Plus RC, Aquabot Ultra and Ultramax Jr.
    • $1.20

  • 97. Brushes - Light Blue PVA Foam (Set of 4)

    Used on the Aquabot Ultra and Ultramax Jr.This is a long lasting brush that provides excellent traction. They can be a little difficult to install.
    • $131.84

  • 99. Drive Track with Traction Tabs (Blue)

    Used for all Model "G" units. Must use spacer brackets for RC and T4 units.
    • $23.35

  • 99. Drive Track (Blue)(each)

    Used for all units.
    • $22.24

  • 101. Filter Bag (Fine)

    For use with the Aquabot Ultra, Aquamax, Aquamax Bi-Turbo, Ultramax Junior, JetMax
    • $72.36

  • 101. Filter Bag (Mesh)

    For use with the Aquabot Ultra, Aquamax, Aquamax BiTurbo, Ultramax Junior, JetMax
    • $70.15

  • 102. FILTER BAG CLIP (pair)

    Black plastic
    • $8.10

  • 103. Filter Screen

    White, Cage. For use with Aquabot Ultra, Aquamax, Aquamax BiTurbo
    • $34.05

  • 104. Screw (#6, 11/16", Phil Pan-Flat Head, Pointed)

    Used to fasten the 5300/5301 Filter Screen to the Body Assembly.

    • $1.27

  • 105. Bottom Lid Assy.

    White, Square Wire Frame. AB Ultra, JetMax, Aquamax, AMAX BiTurbo
    • $115.43

  • 110. Power Supply

    7-Pin, Female, 7-Wire. For use with ALL Ultramax Units
    • $458.16

  • 111. Socket Assy.

    9-Pin, Male, 9-wire. For use with Ultramax Jr., Ultramax
    • $34.05

  • 112. Fuse Holder

    Standard, push and turn style. Always unplug unit before working on electrical system!

    • $8.14

  • 112. Fuse Holder (Phillips Head Style)

    (Phillips Head Style)
    • $8.14

  • 114. Lighted Switch (For most power supplies)

    Standard Red, 3-wire. Always unplug unit before working on electrical system.

    • $8.16

  • 115. Antenna

    4" with Hardware.
    • $11.66

  • 116. TRANSMITTER

    Radio RC, Grey and Yellow with Blue Buttons
    • $89.32

  • 117. Power Supply Handle

    Black plastic, with screws, nuts and star washers.

    • $6.23

  • 119. OUTDOOR TIMER

    8-hour, Programmable, GFCI - Used to regulate cleaner's run time when it does not have an auto shut-off.
    • $46.58

  • Ultrakart

    Steel Construction, fits power supply, cable and unit. Fits any unit. We prefer this unit to the Buggy because it is much better built.
    • $324.50

  • Foam Climbing Rings (Set of 4)

    Light Blue PVA (1" thick)The climbing rings slide over the standard brushes and give the unit more traction for climbing slick surfaces.
    • $26.71

  • Flat Plug (White Plastic)

    Used to plug large holes on the Body where the Cables run through.
    • $1.20

  • Connector (Sky Blue Plastic)

    Used to make "Y" connection in the Nylon Rope Assembly on the cable. (We suggest the Stainless Steel Version)
    • $3.28