JETMAX PARTS
-
-
For fastening the foam-insulated part of a 2-wire cable to the Body Assembly.
-
For end of Cable Assembly. Always Disconnect power before working on the electrical system!
-
-
-
-
Used to fasten the Pump Motor to the Outlet Bottom Ring on the Body Assembly.
-
For Jet Valve - Pool Rover Jr./Plus, Aquajet, ThunderJet IG/ JetMax. 5-Holes for Jet Valve
-
-
For inside of Jet Valve housing of all Jet/Rover units.
-
-
-
-
-
Used around the Cable Assembly on the Body Assembly. For AquaJet, JetMax and Pool Rover Units.
-
Used on Pool Rover Plus, AquaJet, ThunderJet IG and JetMax.
-
-
-
-
Black, For under sideplate. For use with Pool Rover Plus, ThunderJet IG, AquaJet, JetMax
-
Used on the T2, T4, Pool Rover, ThunderJet AG and JetMax.
-
Pump motor comes with a 6 month factory warranty if it is installed by a factory authorized repair center. (Aqua Service Distributors is a factory authorized repair center.) If the motor is not installed by an authorized service center there is not warranty and the the motor cannot be returned. Always disconnect the power before working on the electrical system.
-
-
-
-
-
For T2, T4, Pool Rover Plus, ThunderJet IG, AquaJet and JetMax
-
5-Pin Plug for Pump Motor connection. Electrical parts are non-refundable.
-
-
-
-
Used on the Pool Rover Jr., Pool Rover Plus, ThunderJet IG, AquaJet and the JetMax.
-
-
-
For the Pool Rover, Pool Rover Plus, ThunderJet AG/IG, AquaJet.
-
-
-
-
-
Used to tie onto Clevis pin, attached to Tube or Body. Used on all Jet and Rover Units.
-
For use with the Aquabot Ultra, Aquamax, Aquamax Bi-Turbo, Ultramax Junior, JetMax
-
For use with the Aquabot Ultra, Aquamax, Aquamax BiTurbo, Ultramax Junior, JetMax
-
-
-
-
-
Foam, Plastic and screws. This float gets fastened to bottom lid if cleaner is not climbing the wall high enough.
-
White Foam Blocks. These are inserted into the bottom lid if the unit is not climbing high enough. (The H-Float must be installed in order to install the Side Pocket Floats)
-
-
(3-pin, male, 2-wire) Aquabot, Turbo, Storm, Tempo, Turbo T, T2 Always unplug unit before working on electrical system!
-
-
Thin Red, 3-wire. Always unplug unit before working on electrical system.
-
Front Dial, 2-hour Automatic Shut-Off, No Reset Switch - For Pool Rover/Junior and ThunderJet AG
-
-